Overview

Use the following process to add Child Count lines in TMAS Equipment Inventory to obtain child counts from a 3D Scope II (ONLY) device. A valid object classification license MUST be installed on the counter.

Sections found in this article

• How to Add Child IN / OUT count lines
• How to Add additional count lines for a single 3DScope II device.

How to ADD Child IN and Child OUT sensors for Line 1 (L1) configured in the 3DScope II traffic counter.

Equipment Inventory: Adding Equipment

1. Under the Main Menu/Configure, click Equipment Inventory
2. Confirm that you have the desired 3D Scope II
3. Click Add 
4. Select the Equipment Type: Sensor/Count Line
5. Click Next 
6. Enter the name wanted for the Child In Line
7. Select IRISYS Thermal Imaging IP Camera (Line)
8. Select the desired unit to which you wanted to add the child sensor (if more found in step 2)
9. Click Next 
10. Select Door# 31 for the Child IN Direction
11. SMS default factor is 50%
12. Retail Genie Sensor # should be set to Unassigned
13. Click Next 
14. Click Continue as we need to add the Child OUT Sensor 
15. Select the Equipment Type: Sensor/Count Line
16. Click Next 
17. Enter the name wanted for the Child OUT Line
18. Select IRISYS Thermal Imaging IP Camera (Line)
19. Select the desired unit to which you wanted to add the child sensor (if more found in step 2)
20. Click Next 
21. Select Door# 32 for the Child OUT Direction
22. SMS default factor is 50%
23. Retail Genie Sensor # should be set to Unassigned
24. Click Next 
25. Click Continue as we need to add the Child OUT Sensors 

(Optional) How to Add additional count lines for a single 3DScope II device.

Lines 2, 3, 4 ect.. need to already be setup on the 3DScope II device calibration.

Repeat the above process however use the following door # that correspond.  Properly label the sensor for the Regular Line or Child Line.