Overview

By Default the 3D Scope II camera will report counts to the TMAS software once every 15mins with the traffic for the previous 15min.  This traffic count refresh interval is fine for locations where only a traffic value is required.  However to make the Occupancy reporting feature more accurate, a lower more real time count refresh interval should be enable to allow for the 3D Scope II camera to send traffic every minute or 5 minutes.

The following process will describe how to enable the fast push feature as well as configure existing 3DScope II devices in the equipment inventory to start reporting traffic at 1 min or 5 min instead of the default 15min interval.

How to enable Fast Push in Manage Locations on a Chain

1. Login to TMAS
2. Verify that your Chain or Top of the location tree is selected (Fast Push cannot be enabled on a store / location only)
3. Expand Configure
4. Select Manage Locations
5. Select Advanced
6. Check box labeled "Fast Push Activation"

How to set a 3DScope II device to report counts every 1 or 5 minutes (Fast Push Must Be Enabled)

1. Login to TMAS
2. Select a Location
3. Expand Configure
4. Select Equipment Inventory
5. Select 3DScope II device