Overview

This article will provide you with detailed steps to change the IP of your 3D Scope Generation 1

Steps to change the IP of the 3D Scope 1st Generation

Connect Camera to Laptop

1. Plug PoE Injector power out port to IP traffic counter with network cable
2. Plug PoE Injector data network port to Laptop
3. Plug power adapter to PoE Injector

Give Laptop Static IP to access the traffic counter

1. Win + R
2. Type NCPA.CPL
3. Press Enter
4. Right Click Local Area Connection for your Laptop Lan Port
5. Select Properties
6. Select Internet Protocol Version 4 (TCP/IPv4)
7. Select Properties
8. Use an IP, Subnet and Gateway that is in the range of the traffic counter
9. Press OK
10. Press Close

Verify connection to traffic counter from Laptop

1. WIN+R
2. Type CMD
3. Press Enter
4. Ping the IP that the traffic counter is on
5. Press Enter – You should see 4 replies from that IP which means you should be able to access.

Connecting to counter on its IP to program a static IP or enable DHCP.

1. Open Browser (works best with Edge)
2. Type the IP of the traffic counter in the URL bar
3. Input Default Username and Password
4. Click Communication Settings
5. Check off use DHCP or Input IP, Subnet and Gateway desired
6. Click Save
7. Click Service Tools
8. Click Reboot Device – Allow the camera to complete the reboot cycle before powering off the unit to apply the changes.

Repeat steps to access the camera on the new IP if statically programmed to confirm good. Or verify the DHCP server to what IP was assigned to the MAC address.